News — inert wire
How to Choose a Sinker
Posted by Pam Bialiy on
The following article has been authored by John Heaney. While determining if a sinker is needed is easy; determining what type of sinker needed may be less obvious. USP <711> does allow for sinkers made from twists of inert wire. This can be especially handy for R&D where the method is being developed and an experiment is being run to see if the sinkers provide more consistency to the results. For use in other environments, such as QC, it would require the users to be trained on the correct length of inert wire to cut, as well as the spacing...